This analog temperature controller is used for simple applications with on/off or P control, without deviation indication.
- Build-in Laser Trim ASIC
- Easy to change range
- ON-OFFor time proportional selectable
- Compact, only 86mm in depth
- Wide selection of control output option
- Wide selection of ranges
- Sensor break protection
- Low Cost
- Safety : UL,cUL
- EMC, LVD : CE
||Type J, K
||3-wires PT 100 ohms, DIN or JIS
||See ordering information
||±2 %of span
|Cold Junction Compensatin
||±0.1°C / 1°C
|Rejection of RTD Lead Resistance
||( 0.1°C - 0.025% of PV reading) / ohm
|Sensor Break Protection
||100 ohms max.
|Normal Mode Rejection
|Common Mode Rejection
||3 times / second
||2.2% of span
||1 % of span
||20 seconds for relay output, 1 second for pulsed voltage output, 0.02 second for linear current or voltage output.
||Relay 5A / 240V max. resistive load
||20mA / 32VDC max.
||4-20mA, 0-20mA, max. load 500 ohms
||0- 10V, min. load 500k ohms
||Single turn wirewound potentiometer
|Resolution of set point
||0.2% of span
|Accuracy of set point
|Repeatability of set point
||BTC-902 : HI/LO LED indicators,
BTC-901 : None
||ON (red) LED Lamp,
OFF (green) LED Lamp
||100-130VAC or 200-240VAC, 50/60Hz
||Less than 5VA
|ENVIRONMENTAL & PHYSICAL |
||0 to 90% RH (non-codensing)
||20M ohms min. (500VDC)
||200 m/s² (20g)
||BTC-901: 240 grams,
BTC-902: 270 grams
||48(W)X48(H)X86mm (depth behind panel)
||45 X 45mm
It is installed on the heating material tube of the injection molding machine to control the temperature of the raw material, effectively control the liquid temperature of the plastic and improve the molding quality of the product.
Installed on the hot runner system for temperature control of runners and gates to stabilize the quality of the plastic.
Temperature control on the mold temperature machine, indirectly adjusting the temperature of the mold by adjusting the temperature of the hot fluid, can improve the production efficiency of the product and reduce the generation of defective products.
Electric heating furnace industry
Vacuum furnace equipment / vacuum melting / vacuum heat treatment
A new algorithm for PID adjustment using fuzzy rules is used to adjust the PID algorithm to eliminate the PID saturation integral phenomenon when the error is large. When the error is small, the improved PID algorithm is used for adjustment and can be automatically adjusted. Learn and memorize some of the characteristics of the controlled object to optimize the effect
The temperature control of the electric heating cloth package is often used for the heating of the exhaust pipe valve parts of the semiconductor factory, the panel factory, or the special steel cylinder.
In the semiconductor temperature process control program, the heating system of the chamber, such as the decane process, the dichloromethane process
Ceramic / kiln / glass industry
Ceramic sintering furnace:
The heating process on the sintering furnace controls the heating rate to obtain a finished product with better quality and stability.
Temperature adjustment during kiln firing to obtain a finished product with better quality and stability.
control the temperature during dyeing to a suitable range, which in turn reduces chromatic aberration and improves the quality of dyed products.
The temperature during drying is controlled within a suitable range to improve the fiber product.
Constant temperature and humidity machine
Heating/cooling air conditioning
Pool/bathroom temperature control facility